|
|
|
 |
 |
 |
You are not logged in. Would you like to login?
Offline
Just want to drop in and say hello before I start firing off questions!
Over the last 4 years I have been building a 23 t-bucket. I used an 85 xj12 rear for the build. 2.88 PL. After putting about 500km on it I realized the 2.88's were to tall. So the search began.
Now the bucket is in pieces as I needed to fix an oil leak, and well most of you will know how it goes, "since its apart"....lol
I will post some pics, once I reach my 2nd post.
Offline
Here are some pics of my build.
Thread StarterOffline
Keeper,
Welcome I have looked at your ride here earlier. Pretty bad azz! I like the look of the stance, your a little higher up front, no? What type of front end do you have? Tubular or I beam?
The deep dish rears are nutz! Nice.
Ralphy
Offline
Thanks.
Its the angle of the picture that makes the front look higher, it actually has a little rake to the front.
Its a 4 inch drop tube axle.
The wheels on the rear are 16x10 with 5inch back spacing. I could have gone for a 6 inch bs, but I was not sure they would have cleared the hubs.
Thread StarterOffline
I helped my cousin when I was a kid build one. He wanted to use an I beam but couldn't make it work. That was way back however, early 70's.
1 of 1