Independent Rear Suspension, OEM, aftermarket, stock configuration or heavily modified, all makes and models, everyone is welcome here!!!

You are not logged in. Would you like to login or register?



9/03/2017 7:55 am  #1


Bolt pattern

I am building a 1984 c20 Chevy truck. I have removed all the 3/4 ton suspension and replaced it with 1/2 ton, shortened it to a short bed and lowered it I want to lower it more but don't want to cut up the bed. So I wanted to go with a irs rear. My problem is I have already pick a paid for the wheels I want which are 5x5 bolt pattern   I have found that none of them have my 5x5 bolt pattern  does anyone know of an company that make a kit to convert a Thunberbird, markviii or a corvette to the Chevy 5x5  without adapters

Last edited by Seim55 (9/03/2017 8:00 am)

 

9/04/2017 8:19 am  #2


Re: Bolt pattern

Hi Seim55,

Did something similar on a 8" ford axle. The machine shop turned down the flange where the lug studs used to be and welded on a new turned one with the correct bolt pattern. They heated up the axle while welding the flange, a few minutes on the lathe and it was done. Pretty sure the car still has this axle in use!

Mustsed


Nothing is impossible, some just cost more!
 

Board footera

 

Powered by Boardhost. Create a Free Forum